What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 12:51
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The third is lightning and “how it gets conducted into a home.”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
But it can get overloaded, and no longer works.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is where the MOV conducts again, and dissipated the energy.
United Switches Off Starlink Internet on Regional Jets After Static Problem - WSJ
What does a fuse do?
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At least they know the answer if they wanted it.
He then describes Rainy Season and Lightning.
[image of Common-mode choke]
Proposed NASA cuts to space science: “Staggering” - EarthSky
But… the neutral is now “floating” because of the 1 ohm resistance.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
One is “what exactly is in a ‘surge protector’ ? ”
Taylor Swift Owns Two Versions of Four Albums. Now What? - Billboard
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
These are simplified answers to the original question, and does not change anything I wrote above.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Hegseth warns China poses 'imminent' threat to Taiwan and urges Asia to boost defence - BBC
eight
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
the problem then depends on "how fast does the fuse operate?".
Accidental discovery at New York planetarium unlocks secret into universe’s inner workings - PBS
Barnstars:
[old diagram got deleted by accident]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What is lightning?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
so, what happens?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Because the load is inductive, the current lags the voltage.(by a bit).
A fuse is a non-resetable over current circuit protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
a photo is worth a thousand words.
what exactly is a ‘surge’ protector?
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes the function of a fuse.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is 'the assistant's answer'
In schematic diagrams this is the symbol for a fuse:
A circuit breaker is similar, but is resettable.
The bolt then partially travels down the line to your home.
The other is “what does a “fuse” do?”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–16 [ OO OLAOYE OYEBODE ]
Here is a simplified AC power diagram.
2024–10–10[John johnson John Johnson ]
An AC voltage/ current source, and an ac inductive load.
This one hit behind the barn.
but I think this circuit , shows a few more pieces.
Edit 2024–10.
It seems Mohan does not understand the difference between a comment and an Answer.
First Sentence:
nine
(Dc diagram shown, AC is similar).
At one ohm, the resistor has a maximum of 1 watt power.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Upvotes:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This device then solves the entire problem.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–14 [Omar Gharbi Omar Gharbi ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Now when you have a certain ac resistance, then a current flows in a loop.
These devices are installed between the “hot” and “neutral” and protective ground.
There are three different concepts here that are getting confused.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
He then asserts :
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are two important concepts here.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
It also is a device that limits the change in current flow.
For this case there are devices called Metal oxide varistors (MOV).